installation guide

- 10 -
ROOF CAP
6-INCH
ROUND DUCT
HOOD
UNDER
EAVE
VENT
6-INCH
ROUND
ELBOW
24" TO 30" ABOVE
COOKING SURFACE
(see “MOUNT TELESCOPIC
MOUNTING ARMS” section for
mounting restrictions)
INSTALL THE DUCTWORK
DUCTED HOODS ONLY
(AEIC35SB required)
CAUTION: To reduce the risk of fire,
use only metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
Fig. 9.
2. A straight, short duct run will allow
the hood to perform most efficiently.
3. Long duct runs, elbows, and transi-
tions will reduce the performance of
the hood. Use as few of them as pos-
sible. Larger ducting may be required
for best performance with longer duct
runs.
4. Install a roof or wall cap. Connect
6" round metal ductwork to cap and
work back towards hood location. Use
duct tape to seal the joints between
ductwork sections.
FIG. 9
MOUNT TELESCOPIC
MOUNTING ARMS
1. Tape the mounting template in place
and drill (12) 1/8" diameter holes at the
center locations shown. Fig. 10. When
complete remove template from ceil-
ing.
1/8 IN. DIAMETER
LOCATIONS (12)
FIG. 10