installation guide

- 16 -
18. Remove the grease filter at bottom
of hood. Mount the hood onto the
telescopic arms using (4) M4x8 ma-
chine screws. Fig. 24. Make sure the
electrical cord is on the proper arm
with the junction box and incoming
power. Pull the safety cable from the
extension arms into the hood. Fig.
24.
19. Secure safety cables as shown in
Fig. 25.
A. Push cable through support rods
and into hood cavity.
B. Slide washer and cable clamp with
barrel nut onto cable.
Note: Barrel nut must be slightly
backed off of cable clamp and
pushed (spring compressed)
when sliding assembly onto cable.
C. Push clamp assembly all the way
to the top of the hood while push-
ing down on barrel nut. Fig. 26.
D. When assembly is all the way to
the top inside of hood, completely
tighten barrel nut.
E. Cut excess cable off.
FIG. 24
ELECTRICAL CORD
FIG. 25
M4 X 8 MM MACHINE
SCREWS - (2) PER ARM
HEX NUT
NOTE: CABLE CLAMP ASSEMBLY
INCLUDES BARREL NUT AND
HEX NUT.
BARREL NUT
EXCESS CABLE
CLAMP ASSEMBLY
FIG. 26