installation guide

- 18 -
FOR NON-DUCTED AND DUCTED
FLUE VERSION
24. Remove the protective grille at the
top of the hood and the bottom grease
filter. Fig. 31.
25. For the ducted version install the
duct connector onto the blower inlet.
Fig. 32.
26. For non-ducted version insert the
6"-5" reduce over the blower open-
ing and duct tape into place. Fig. 32.
27. Mount the hood onto the telescop-
ic arms using (4) M4x8 machine
screws. Make sure the electrical cord
is on the proper arm with the junction
box and incoming power. Pull the
safety cable from the extension arms
into the hood. Align the duct work
with the blower opening or reducer
opening. Fig. 33.
FIG. 31
FIG. 32
DUCT CONNECTOR
6" TO 5" REDUCER
5" EXPANDABLE DUCT
non-duct applications only
FIG. 33
M4X8
MACHINE
SCREWS