installation guide

- 19 -
28. Secure safety cables as shown in
Fig. 34.
A. Push cable through support rods
and into hood cavity.
B. Slide washer and cable clamp with
barrel nut onto cable.
Note: Barrel nut must be slightly
backed off of cable clamp and
pushed (spring compressed)
when sliding assembly onto cable.
C. Push clamp assembly all the way
to the top of the hood while push-
ing down on barrel nut. Fig. 35.
D. When assembly is all the way to
the top inside of hood, completely
tighten barrel nut.
E. Cut excess cable off.
29. Remove the upper flue mounting
screws and drop the flues to expose
the wiring box. Make final electrical
connections. Install the outlet box
cover with (2) 3.9 x 6 mm Flat Head
Screws and (2) 3.9 mm lock wash-
ers. Fig. 36.
30. Reinstall the upper flue covers with
(4) 3.9 x 9 mm pan head screws.
Fig. 37.
31. Attached the bottom flue covers.
Fig. 38.
FIG. 34
HEX NUT
NOTE: CABLE CLAMP ASSEMBLY
INCLUDES BARREL NUT AND
HEX NUT.
BARREL NUT
Excess Cable
Clamp Assembly
FIG. 35
FIG. 37
3.9 X 9 MM PAN
HEAD SCREWS (4)
FIG. 36
FIG. 38