CPDI Installation Guide

- 4 -
HOOD LINER
10” ROUND DUCT
36” MIN.
ABOVE
COOKING SURFACE
10” ROUND ELBOW
CPD (DUAL INTERNAL BLOWER)
TYPICAL DUCTWORK
1. INSTALL DUCTWORK AND ELECTRICAL WIRING
INSTALLATION
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use 10” round ductwork.
Use metal foil duct tape to seal duct joints.
The minimum hood liner distance above cooktop must not be less than 36’’.
Distances over 36” are at the installer and users discretion.
Run 3-wire power supply cable to installation location. Its length should extend at least 4 feet below the bottom of the
custom hood.
2. PREPARE THE INSTALLATION
WARNING
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
Make sure that the following items are included:
- Hood Liner
- Accessories: • Bafflefilters(2for36’’width,3for48”and60”widths)
  • Shieldedhalogenlamps(120V, 50W,MR16withGU10baseorPAR16withGU10base)(2forCPDI362,
4 for all other models)
  • 10”roundadapter
  • Bagofpartsincluding:12-#8x½”flatheadscrews(16-forCPDI602),4-M4x6panheadscrews,
1 - suction cup tool, 3 - wire nuts
Parts sold separately:
- Ducts, elbows, wall and roof caps. Refer to pages 3 and 4 for a complete list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
VQ0010
!
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.