Installation Manual

ManualsBrandsBestop ManualsAutomotiveBestop 39436-37 TrailMax II Spice Front High Back Vinyl All-Vinyl Single Jeep Seat for 1976-2006 Jeep CJ and Wrangler

Installation Instructions

INSTALLATION TIME

SKILL LEVEL

1 Hour

2 - Moderately Easy

TOOLS

Vehicle Application

• All Jeep CJ5s, CJ7s

and Wranglers

1976 – 2002

Part Number: 39436

TrailMax™ II High Back

Bucket Seat

www.Bestop.com - We’re here to help! Visit our web site and click on “Ask a Question”. Click here for more Jeep Accessories by Bestop.

13 mm and

12 mm Hex

1997 – 2002 Vehicles must use Adapter Bracket Part Number 51256.

Summary of content (5 pages)

PAGE 1
Installation Instructions TrailMax™ II High Back Bucket Seat Vehicle Application • All Jeep CJ5s, CJ7s and Wranglers 1976 – 2002 Part Number: 39436 1997 – 2002 Vehicles must use Adapter Bracket Part Number 51256. www.Bestop.com - We’re here to help! Visit our web site and click on “Ask a Question”. Click here for more Jeep Accessories by Bestop.
PAGE 2
TrailMax™ II High Back Bucket Seat – Installation Instructions Parts List and Hardware Identification Assemble Seat Release the fabric flap on the side of the Seat Bottom to access the bolt holes. Align the holes in the brackets on the Seat Back with the holes in the Seat Bottom. Install an M10 x 20 Bolt in each hole. Tighten the bolts securely. Replace the fabric flap over the bracket and hook it to the bottom of the seat.
PAGE 3
TrailMax™ II High Back Bucket Seat – Installation Instructions DO NOT reuse the original mounting bolts. Reuse of the bolts could cause the seat to loosen, which could result in loss of control of the vehicle, causing bodily injury to the vehicle occupants and to others. Remove the Tracks Track Lay the seat down with the bottom side facing up. Push down on the track bar to slide the track forward, allowing access to the rear track mounting bolts. Remove the bolts and discard them.
PAGE 4
TrailMax™ II High Back Bucket Seat – Installation Instructions Install the tracks on the Bestop Seat Press down on the track bar and slide the tracks forward. Install two of the M8-1.25x25 Bolts from the Parts Kit in the rear track mounting holes. Tighten the rear bolts to 21 ft/lbs, using a 13mm Wrench. Insert M8-1.
PAGE 5
TrailMax™ II High Back Bucket Seat – Installation Instructions For proper use of child seats in this vehicle, refer to the instructions provided with the child seat and to the vehicle owners manual. Never adjust the driver’s seat or seat back when the vehicle is moving. You could loose control of the vehicle and injure someone. This seat system is intended to be used with seat belts at all times. Do not rely on the seat to maintain the seating position of occupants, in the event of an accident.