Installation Manual

Rev. 2 0907
TrailMax™ II High Back Bucket Seat – Installation Instructions
39436 pg. 3
DO NOT reuse the original mounting bolts. Reuse of the
bolts could cause the seat to loosen, which could result in
loss of control of the vehicle, causing bodily injury to the
vehicle occupants and to others.
Remove Bolts
& Throw Away
Seat Cushion
(Front)
Track
Track Bar - Push
down to slide
Track forward
Lay the seat down with the bottom
side facing up. Push down on the
track bar to slide the track forward,
allowing access to the rear track
mounting bolts. Remove the bolts
and discard them.
Remove the Tracks
Track
Track Bar - Push
down to slide Track
toward rear
Push down on the track bar again to slide the track toward the rear of
the seat. Remove the front track mounting bolts and discard them.
Do not throw away the tracks, they will be mounted to the Bestop seat.
Remove Bolts
& Throw Away
Seat Cushion
(Front)
Remove the Tracks
Your new Bestop seat has two (2) mounting holes on each side
of the front and three (3) holes on each side of the rear. This
allows tracks from various Jeep models to be used with the Be-
stop seat. Locate the correct mounting pattern by placing the
track on the seat and positioning the track so that the four holes
in the track align with four mounting holes in the seat, allowing
the track to be positioned in the center of the seat.
Track
Select front holes
in seat that best
center the track
on the seat
Seat Cushion
(Front)
Rear
Select rear holes in
seat that best center
the track on the seat
Hole Pattern
Use only the bolts provided in the Parts Kit when installing the new
seat. Failure to do so may cause the seat to loosen, resulting in loss
of control of the vehicle and causing serious bodily injury to the vehicle occupants and to others.
Track
Bar
Track
Insert M8-1.25x25 Bolts from
Parts Kit - Finger Tighten
Seat Cushion
(Front)
Lay the Bestop seat down with the
bottom of the seat facing up. Select
the hole pattern on the seat that
applies to your vehicle.
While the track slides are to the
rear of the seat, place the tracks
onto the Bestop seat. Install two
of the M8-1.25x25 Bolts from the
Parts Kit in the front track mounting
holes. Finger tighten the bolts.
Install the tracks on the
Bestop Seat