Installation Manual

Rev. 2 0907
TrailMax™ II Pro Reclining High Back Bucket Seat – Installation Instructions
39450 / 39451 / 39460 / 39461 pg. 3
Track
Track Bar - Push
down to slide Track
toward rear
Push down on the track bar again to slide the track toward the rear of
the seat. Remove the front track mounting bolts and discard them.
Do not throw away the tracks, they will be mounted to the Bestop seat.
Remove Bolts
& Throw Away
Seat Cushion
(Front)
Remove the Tracks
Your new Bestop seat has two (2) mounting holes on each side of the front and
three (3) holes on each side of the rear. This allows tracks from various Jeep
models to be used with the Bestop seat. Locate the correct mounting pattern
by placing the track on the seat and positioning the track so that the four holes
in the track align with four mounting holes in the seat, allowing the track to be
positioned in the center of the seat.
Track
Select front holes
in seat that best
center the track
on the seat
Seat Cushion
(Front)
Rear
Select rear holes in
seat that best center
the track on the seat
Hole Pattern
Use only the bolts provided in the Parts Kit when installing the new seat. Failure to do so may cause the seat to loosen,
resulting in loss of control of the vehicle and causing serious bodily injury to the vehicle occupants and to others.
Track
Bar
Track
Insert M8-1.25x25 Bolts from
Parts Kit - Finger Tighten
Seat Cushion
(Front)
Lay the Bestop seat down with the bottom of the seat
facing up. Select the hole pattern on the seat that ap-
plies to your vehicle.
While the track slides are to the rear of the seat, place
the tracks onto the Bestop seat. Install two of the
M8-1.25x25 Bolts from the Parts Kit in the front track
mounting holes. Finger tighten the bolts.
Install the tracks on the Bestop Seat