Automobile Accessories User Manual

51403 10
Rev. D 1298
WILLY'S
Step Seven
Thread the buckle strap assembly through each Footman Loop and then back through the
buckle. Do not over tighten. Wrap the fabric flaps, sewn to the top above and behind the
doors, around the horizontal rods and vertical retainers and fasten the hook and loop
fasteners. Fasten the hook and loop fasteners around the Front Bows. (The Vertical
Retainer Mounts may be adjusted forward or backward if needed.)
Step Eight
There is a snap on each front corner of the top fabric. Pull the fabric forward and down to
eliminate wrinkles. Mark the locations for the Body Studs. Center punch and drill 3/32 inch
holes. Install the Body Studs with #6 x 3/8 inch Sheet Metal Screws. Make sure that the
fabric is centered on the windshield. Failure to center the fabric could result in torn
fabric.
Adjusting the Top
Rear Curtain
To roll up the Rear Curtain, start at the bottom and roll it to the inside. Avoid wrinkles in
the fabric and window. Secure it in place with the curtain strap inside of the top (see
Figure 11).
Side Curtains
To roll up the Side Curtains, fold the bottom rear corner of the panel forward and roll the
curtain to the outside. Avoid wrinkles in the fabric and the windows. Secure the curtain in
place with the curtain straps inside the top (see Figure 12).
Figure 12
Second
Fold
First Fold
WILLY'S
Figure 11
Detail of Rear
Curtain
Curtain Up
Curtain Down
Strap
Rear Window
Fabric
Side View
Area detailed
at right