Manualshelf

Automobile Accessories User Manual

ManualsBrandsBestop ManualsAutomobile AccessoriesCJ3A
45678910111213
51403 12
Rev. D 1298
Step Two
Once the door is in position, mark the location for the Lower Door Hinge. Center punch
and drill two 5/32 inch holes. Secure the Lower Door Hinge using two #10 x 1/2" Pan
Head Sheet Metal Screws (see Figure 14).
Step Three
For best results, the window should be zipped closed for this step.
Install the body studs by marking the snaps on the door fabric with chalk, holding the door
open 12 inches and pulling the fabric forward.
Note: Do not hold the door open more than
15 inches when installing the body studs. Fabric may tear or the snaps may pull out of the
door fabric when the door is closed.
Press the snaps against the body. The chalk will
leave marks for the body stud locations. Center punch and drill 3/32 inch holes at the
marked locations. Install a body stud with a #6 x 3/8" Sheet Metal Screw.
Repeat these steps for the other door.
Folding the Top Down
Step One
Unsnap the Rear and Side Curtains and unzip the Rear Curtain zippers.
Fold the Side Curtains along the seam and up over the top. Fold the
Rear Curtain up over the Side Curtains. Unfasten the hook and loop
fasteners around the Vertical Retainer and the Horizontal Rod. Release
the locking tabs on the bow releases from the holes in the Front Bow
and slide the Rear Bow down to the Bow Mounts. Insert the bow
release tab into the hole on the Front Bow, just above the Bow Mount.
Remove the Vertical Retainer and the Horizontal Rod from their
mounts and pivot the Front Bow to the rear of the vehicle until it
makes contact with the Rear Bow (see Figure 15).
Step Two
Unfasten the top from the Windshield Retainer and lay the top down
on the body (see Figure 16). Fold the top in half from front to back
and continue folding until the top is about one foot wide at the rear
of the vehicle (see Figure 17). The Buckle Strap assemblies may be
used to secure the top to the bow assembly.
Step Three
Secure the Vertical Retainers and the Horizontal Rods by snapping
each of the Bow Tie Down Straps to a body stud.
Figure 15
Figure 17
Figure 16