Automobile Accessories User Manual

51403 6
Rev. D 1298
Figure 4
Footman Loops
CAUTION: Installation of the Footman Loops involves drilling in the top edge of the
vehicle body. Check under the body edge at the marked locations. There may be wiring
for the rear lights. If so, pull the wiring out of the way before drilling.
Step One
Install the Footman Loops on the top rear corners of the vehicle. Use the loops as
templates to mark, center punch and drill 5/32 inch holes. Use two #10 x 1/2 Oval Head
Phillips Screws to secure the loops in place (see Figure 4).
Footman Loop
WILLY'S
Area detailed at right
Windshield Channels and Upper Door Hinges
Step One
Drill a 3/8 inch hole in each upper, inside corner of the windshield frame (see Figure 5).
Do not drill all the way through the windshield frame. Some vehicles may have a 5/16 inch
hole at this location. If so, drill out to 3/8 inch. These holes will be used to secure the
Horizontal Rods to the windshield frame.
Figure 5
WILLY'S
Area detailed at right
Top of Windshield Frame
Drill 3/8" hole. Locate
hole in the middle of
the corner.
Notice: Model CJ3A and use existing windshield channels, upper door hinges. If these original parts have been removed,
order part number:
256.82 Windshield Channel, Qty. 2.
200.48 #8 x 1/2" Self-tapping Phillips Screw, Qty. 6.