Automobile Accessories User Manual

51403 8
Rev. D 1298
WILLY'S
Figure 8
Area detailed at
right
CJ3A
Step One
Drill a 3/8 inch hole in the inside of the windshield frame 3 1/4" above the Upper Door
Hinge (see Figure 8). Do this on both sides. Do not drill all the way through the windshield
frame. Note: Some vehicles may have a hole close to this location. If so, use that
hole. These holes will be used to secure the Horizontal Rods to the windshield frame.
Top Fabric Installation
This section will require two people.
Step One
Rotate the front bow assembly forward and insert the Vertical Rods into the Vertical
Retainer Mounts (see Figure 9). Insert the Horizontal Rod into the hole in the windshield.
WILLY'S
Figure 9
Area detailed at
right
Left Vertical Retainer
Outside of Vehicle
Left Side of Vehicle Shown
Left Vertical Retainer
Mount
Top of Windshield Frame
3 1/4"
Drill 3/8" hole