Operation Manual

BFB-3000 Set Up and Operations Manual
Document No: D100253 22
The ‘Level Bed’ function moves the extruder carriage around the corners of the bed so the
operator can adjust the bed bolts to achieve a level bed.
 Check the bed is fitted correctly (page 14).
 On the control panel select ‘Settings’, ‘Level Bed’ function and press enter:
RUN FILE
EXTRUDER MAPPING
MANUAL MOVE
EXTRUDER CONTROL
HOME TOOL HEAD
>
SETTINGS
EXTRUDER OFFSETS
>
LEVEL BED
SET Z HEIGHT
SET BED TYPE
GENERAL SETTINGS
 Press Z+/- to raise the bed to adjust the gap between the hot end and bed. Start with
approximately 10 mm distance between the nozzle and the bed. This will enable
rough levelling.
10 mm