User's Manual

SERVICE
10
Replacing the Lift Rollers
1. On a paved, level surface, pull trailer onto 4x6
blocks. Jack up and unhitch the trailer.
2. Lower the deck until the front or rear lift rollers
can be removed from the roller access holes.
3-1/2
The deck must be supported by the paved
surface or shoring before the lift rollers are
removed.
3. Loosen the setscrews that prevent the rollers
from backing out. The setscrews are located
on the trailer frame where the rollers thread
in. Use a socket wrench, with a 1 1/2” socket,
to unscrew and remove the rollers. Install and
tighten new rollers. Retighten the setscrews.
NOTE: It is easier to remove and replace one
roller at a time. You can adjust the jack to access
each roller.