user manual

2 OPERATOR CONTROLS
The operator controls are located on the control panel. The
Function Interrupt and the Wedge Control direct the movement
of the wedge during splitter operation. Refer to Figure 3-2.
Before operation of the splitter can begin, hardware for the
Function Interrupt and the Wedge Control must be assembled.
The hardware is located in the tool box attached to the unit. A
pair of needle-nose pliers and a 3/8 inch wrench or adjustable
wrench are needed for control hardware assembly.
WARNING
BEFORE USE
dop the ther uohjoh ihkjnlkjh
dhiug oj yho jk;lk poj;lm
gygyt bjkj jklj kpj
hjohoi poio [pl\
DURING USE
huig bnmlkh nhfgij bj l
hguijkp [p]][p\[\
hioiupo p
ji0 \ junoitgbjtbvktv
gutj guit uyoip jip jkop jop
njt u you jlpi
‘
huo po[k
BEFIREN UI HU HUDE FORE
OPERA
TING INSTRUCTUIBE
TH GY HYGF FDYTIU HOUH
VBHVJH
GUI
VHGUTR HIO KKOO IP
TUY UYO FGJ FRREWHFVHGI
BJHGYOU TGYUFRJ ETR
Y
HU HOI GUYGGHFJHVJH
FGYYF GOIU
HUO HIOI I YUY FYFIGUGL
UGIUG G
YGI
HUO FGYUGUO UOOIPP
FUNCTION
INTERRUPT
WEDGE
CONTROL
RETURN
SPLIT
WARNING
STAY CLEAR
MAXIMUM TOWING SPEED
35 MPH
CONTROL
PA N E L
FUNCTION
INTERRUPT
TOOL BOX
WEDGE
CONTROL
Figure 3-2. Operator Controls
Function Interrupt Control Hardware Assembly
1. In the back of the control panel, connect the link to the
handle with the short clevis pin and cotter pin
provided in the hardware kit. Refer to Figure 3-3.
2. In the front of the control panel, attach the knob with
threaded stud to the handle with the 3/8-16 nut and
3/8-16 locking nut provided in the hardware kit.
Tighten both nuts to secure the knob to the handle.
Press the handle down to test Function Interrupt
control operation.
14