KV HOSE KIT P/N 891125 BILLY GOAT KV HOSE KIT (P/N 891125) PURPOSE: To allow for vacuuming in hard to reach places.
KV HOSE KIT P/N 891125 INSTALLATION: Step 1. Attach nozzle wear guards. 1. Disconnect spark plug wire. 2. Raise the nozzle height to its highest position and secure the unit from moving. 3. Remove the two bolts, nuts and washers on the sides of the nozzle that hold the reinforcement bracket on the interior of the nozzle. Do not discard the old hardware. 4. Slide the guards into place then secure the guards with the hardware previously removed. 5. Tighten the hardware using two 7/16” wrenches. 6.
KV HOSE KIT P/N 891125 INSTALLATION: continued Step 3. Attach coupler (item 8) and nozzle to hose. 1. Slide the two hose clamps over both ends of the hose and at one end attach the coupler to the hose using a 5/16” nut driver. Note: the hose is attached to the end of the coupler without the pin. Make sure the hose is completely seated next to the plate and secure it with one of the hose clamps.
KV HOSE KIT P/N 891125 Operation 1. Simply slide the plate (item 10) onto the wear guards till the front is flush with the front edge of the nozzle. To remove simply apply pressure to the outside edges at the wear brackets and slide forward. This will allow suction through the hose when attached rather than the nozzle. To remove the plate push outward on the tabs and this will allow you to slide the plate off.
KV HOSE KIT P/N 891125 HOSE CARE & SHIPPING INFORMATION SHIPPING TAG IMPORTANT NOTICE This merchandise was in perfect condition when packed and shipped. Unpack immediately and check for damage. Place any damage claim with delivering carrier and have inspection made at once. Our warranty covers manufacturing defects only. DO NOT RETURN TO SHIPPER. SHIPPER-WARNING TOP LOAD ONLY TO PREVENT SHIPPING DAMAGE. HOSE CARE • ATTENTION! Hoses are wear items and are only warranted against manufactures defects.
