Operation Manual

Binatone Help Line - 0845 345 9677 Calls are charged at Local Call rate.
6
Desk/Wall mounting continue...
Insert the rigid clips of the stand into the slots
on the bottom of the phone (nearer the centre of
the base). Press down firmly until the flexible
clips clicks into place.
To remove the stand, (1) pinch the flexible
clips, (2) pull back the stand, and then (3)
slide up and forward as shown below.
Mark two points on the wall that are 92 mm
apart to lay the fixing centers as shown below.
BE CAREFUL to check that there are no
electrical wires hidden in the wall.
Hang the telephone on the screws using the
wall mount slots. You may need to remove the
telephone from the wall and tighten the
screws so that the Telephone is securely fixed and
does not wobble. Place the Handset on the
cradle with the parking hook on the cradle
arranged to fit in the parking recess under the
earpiece on the Handset.
92 mm
Fix two screws (7mm head screws required, not
approximately 7mm
between the wall and the screw
leaving
supplied) at the marked locations,
head.