Operation Manual

NAVIGATION

8.5 Day/Night Mode

Allows you to change the map so that the colour and brightness are optimal for driving in either

day time or night time conditions.

There are two options to choose from; manually and automatic.

Manually – when selected allows you to either

simply select day or night mode, by tapping either

or to make your selection.

Automatic – When selected allows you to set a

start and end time, when the time is between

these two times the unit will be set to Day mode.

At all other times the unit will automatically switch

to Night mode. You can set a start time of

between 1:00 till 12:00 AM and an end time of

between 1:00 till 12:00PM. Use the and

buttons to select the start and end time.

This way you can customise the Day/Night Mode for any time of year.

Once set tap

to confirm the selection and return to the settings screen. Tap to return

to the settings screen without saving.

8.6 Set Home Address

Allows you to set your home address so that it can be easily used when navigating. When tapped

you will be able to add a location from the options available when entering a destination under the

Go to section (see page 19). Note: the Go Home option will not be available.

If you need to change your home address at a later date, simply tap Set Home Address again to

re-enter your address.

8.7 GPS Status

When tapped the screen will change to the

GPS status screen, Note; this can also be

brought up by tapping from any of the

navigation screens.

This screen shows you information about your

current GPS position. Including the date & time,

your current speed, your current altitude above

sea level and your current position in Longitude

and latitude.

Included with this information is the number of satellites which you are currently locked on to. The

right half of the screen shows the position of these satellites in the sky. Each satellite will be

shown by a coloured circle; Blue means that the unit has locked on to the signal, while grey means

that the satellite has be found but the unit is not currently locked on to its signal. Each satellite will

be identified by a specific number shown inside the circle.