User`s manual

25
USER’S MANUAL Service and Maintenance
Level 2 Service and Maintenance
Level 2 Service and Maintenance
are additional items that need to be
checked at each 3000 mile interval. These items should be checked in
addition to the standard Level 1 servicing.
1. Check the condition of the transmission clutch. Excessive wear on
the clutch pad material indicates replacement is necessary.
2. Drain and replace brake fluid.
3. Inspect and clean the carburetor, air filter, fuel tank, fuel filter.
4. Clean and apply fresh grease to the upper and lower bearings of the
steering column.
5. Check the front and rear tires for wear. Inspect for signs of damage.
6. Clean, inspect and lubricate all cables on the vehicle. Any signs of
fraying or damage indicate the need for replacement.
7. Drain the transmission fluid and replace. Ins
pect and clean all
tranmission components, checking for wear of the variator and
tranmission belt. Replace as necessary.
8.
Verify all electrical controls and switches function normally. Replace
any lightbulbs that are not working.
Level 3 Service and Maintenance
Level 3 Service and Maintenance
are additional items that need to be
checked at each 6000 mile interval. These items should be checked in
addition to the standard level 1 and 2 servicing.
1. Inspect the frame for damage.
2. Inspect the transmission gearbox for damage and wear to the gear
teeth.
3.
Ensure normal operation, of front and rear automatic clutches and
the drive system.
4. Check whether there is any crack, erosion, spalling
or serious
stepped wear on each gear tooth of the rear transmission box.
5. Ensure normal range of motion and rebound for the front and rear
shock absorbers.
6.
Check entire fuel system. Verify all hoses and connections are
secure and no leaks are present.
7. Check for damage to the front steering column. Any signs of the front
wheel not being properly aligned indicate damage. The steering
column must be replaced in the event of any signs of damage.