User`s manual

33
USER’S MANUAL Service and Maintenance
Adjustment of the rear brake light
*
It is important to always check the vehicles lights are properly
functioning prior to using the vehicle.
The brake light can be
inspected with the ignition turned to the on position, and the left
brake handle pressed.
*
When applying the front and rear brakes, each side should turn the
rear brake light on when pressed individually. Switches mounted to
the inside of the brake handles cause the brake light to turn on when
pressed.
Adjustment of the idle speed
If the vehicle stalls out during normal operation due to the engine speed
being too low, the idle speed of the can be adjusted as outlined in the
following steps:
*
Before adjusting the idle, make sure the engine has reached normal
operating temperature.( typically 5-10 minutes of driving )
* Place vehicle on the center kickstand.
* With the engine running, adjust the idle speed to the specified value.
* If the engine dies .
In order to gain access to the brake switches the left and right side
controls m
ust be removed as well as the brake handles. This can be
performed at your local authorized service center.
Adjust the idle speed screw here. Turning clockwise will raise the
idle; counter clockwise will lower the idle.
Front brake
light
switch
Rear brake
light
switch