User Manual

14 15
HOW TO USE
Power on/off Button
Push the button to power on.
Push and hold the button to power
off. Press during a wash to stop
all operations.
Auto Rear Wash
Press the auto rear wash button.
When seated, press the auto rear
button to start a rear wash for 1 minute,
followed by the dryer function for 4
minutes. If you press the button again
during a wash, it will skip to the dryer.
Auto Front Wash
When seated, press the auto front
button to start a rear wash for 1 minute,
followed by the dryer function for 4
minutes. If you press the button again
during a wash, it will skip to the dryer.
Blackout Flush
When the product is unplugged,
press the Power/Stop button. If
the toilet is not flushing properly,
replace the battery.
Auto Flush
When the seat sensor no longer
detects a user, it will automatically
flush. The toilet will only
flush once.
NOTE: After 24 hours, product
will automatically go into power
saving mode and all functions will
shut off. To turn back on, simply
push the Power button on the
Side Control Panel.
TESTING (CONT.)
Matching Your Remote Control Code
Your remote control will be matched with a code
at the time of delivery. In the case that your remote
control malfunctions, match the codes as per the
following method.
1. Unplug your product. Press and hold the
stop key until the level indicators flicker.
2. Place the remote control close to the product
and plug your product back in.
3. The level indicator should stop flickering and all
lights should be on normally. All level indicators
should light up red (normal).
4. Codes are matched properly when
all lights are on.
Press Front or Rear button
to activate oscillating wash
cycle. Press again to turn
off oscillating movement.