OWNERÕS MANUAL
PARTS INCL UDE D X2 DLS BIDET SEAT REMOTE CONTROL AAA BATTERY CATCH PLATE T-VALVE 1/2Ó CONVERSION NUT (OPTIONAL) BIDET HOSE TOILET HOSE (1/2Ó to 1/2Ó) (7/8Ó to 3/8Ó) MOUNTING SCREWS GUIDES RUBBER ANCHORS INSTALL SCREW ASSEMBLY 1
S EA T INSTA L L A T I ON G UIDE 1. Attaching the rubber anchors 2. Attaching the mounting plate Remove the existing toilet seat and insert the rubber anchors into the mounting holes. Place the catch plate and guides over the mounting holes. Insert the mounting screw and secure the catch plate to the toilet. rubber anchors mounting holes mounting plate 3. Attaching the bidet seat mounting screw guide rubber anchor 4. Seat sensor Slide the bidet seat all the way on to the catch plate.
REM O TE I NSTA L L A T I ON G U IDE 1. Installation a. Drill two 6mm holes on the wall that line up with the remote bracket. d. Use the provided screws to attach the remote control bracket to the wall. b. Install the wall anchors in the newly drilled holes. e. Place the remote control on the bracket. c. Place the remote bracket over the wall anchors. 2. Remote Pairing (Follow these instructions if the bidet seat is not responding to the remote) 3 a. Unplug the bidet seat. c.
FUN C TIO NS & S ET T I NG S OPEN/CLOSE COVER OPEN/CLOSE SEAT FRONT REAR Open or close the lid. Activate oscillating front wash. Press again to turn off oscillation. Open or close the seat. Activate oscillating rear wash. Press again to turn off oscillation. NIGHT LIGHT Turns the night light on/off. STOP Stop any operations. DRYER Press to activate the warm air dryer. Press again to adjust the fan speed.
M A INTENA NCE & WA RRANTY CLEANING THE UNIT Wipe the seat with a dry or damp cloth using a neutral cleaning solution Do not use harsh cleaning chemicals, as those can cause damage or discoloration. EXTENDED TRAVEL When the seat will not be used for more than a few days, it is recomended to unplug the unit and turn off the water shutoff valve.
SPECIFICATIONS S PEC IF ICA TI ON S Model 1050WDLS Discovery Rated Power 1050W Rated Voltage 120V, 60Hz Waterproof grade IPX4 Seat Temp Off / 93.2~102.2°F Water Temp Off / 95 ~ 102.2°F WaterDimensions Temp Product 20.79” x 16.38” x 5.59” Ambient Temp Requirement 102.2° F Water Heating Instant Air Temp 102.2° F WARNING ATTENTION The product must be reliably grounded. Do not use the "high" or "medium" range of seat temperature, warm air/wind temperature for a long time.
Phone: 847-458-2334 Email: support@biobidet.com Chat: www.biobidet.
