Owner manual

11
lifestyle Upgrade
Installation Manual and Operating Instructions
lifestyle Upgrade
10
Installation Manual and Operating Instructions
INSTALLATION
Turn the water valve to the left and see if there is any water leaking from the hose.(①~⑤)
Connect the power cord to the 120V electric outlet.
•If the power light does not appear after plugging in the electric cord,
press any button on the remote control.
•If you hear a ‘beep’sound, then the lights will appear on the
power lamp.
•In order to check whether the functions work, you will first need to touch the seat or sit on it to
activate the skin sensor.
•Please be aware that water will come out. This product can only operate when the user sits on the
electronic toilet seat.
•If the tank is full, then a low beeping sound will occur which indicates that
preparation is complete.
If you press or button, the water will begin to enter the heated water tank.
Function Check
Water supply valve
①
②
③
④
⑤
※ Please follow the instructions below when moving or separating the unit from the toilet for cleaning purposes
Unit separation
button
Unit separation button
Disconnect the power plug
Disconnect the T-valve from the water supply. (Refer to page 8~9)
Connect the water hose to the toilet which was disassembled while installing the electronic toilet seat,
and turn the water valve to the left to open it. See if there is any leaking from the water hose connection.
Re-install the toilet seat and lid that was separated when installing the electronic toilet seat.
Shut the water supply valve
Push and hold the button on the right side of the unit to
completely drain the water from the water tank.
Loosen the nut on the hose that is connected to the unit,
and then separate the electronic toilet seat from the toilet
in the following order as illustrated.
•While pushing the button (area shown as an arrow) push the electronic toilet seat slightly toward to the front
and then the body unit will begin to slide out.
Next, lightly pull the unit toward the front and it will detach from the toilet.
•As explained above, steps 1~4 are instructions for separation of the unit for basic cleaning purposes,
and steps 5~7 are instructions for separation when moving, etc.
Do not turn the seat upside-down. This can cause damage to the unit as well as fire hazard.
󰬒
󰬓
󰬔
󰬕
󰬒
󰬓
󰬔
󰬕
󰬖
󰬗
󰬘
4 Initial Operation 5 Separation of unit from the toilet bowl