Manual

C1000 Touch
TM
Thermal Cycler Manual
vi
device” under 47 CFR 15.103(c), in regard to the cited FCC regulations in effect at the
time of manufacture
• Note regarding Canadian EMC compliance: Le present appareil numerique n’emet
pas de bruits radioelectrique depassant les limites applicables aux appareils numeriques
de class A prescrites dans le reglement sur le brouillage radioelectrique edicte par le
Ministere des Communications du Canada
•Cables. Shielded cables must be used with this unit to ensure compliance with the Class
A FCC limits
Battery
The C1000 Touch thermal cycler uses a 3 V lithium-metal coin cell battery and a 4.8 V nickel-
metal hydride rechargeable battery pack to maintain time settings and run data in the event of
AC power loss. If the time and/or run data do not remain set after the unit is turned off, it may
be an indication that the batteries are getting weak. If this occurs, contact Bio-Rad Technical
Support (See “Bio-Rad Laboratories Resources” on page ii.) for assistance.
WARNING! Do not attempt to change the batteries. Contact Bio-Rad technical
support.
FOR THE STATE OF CALIFORNIA, USA ONLY
Perchlorate material – special handling may apply, see www.dtsc.ca.gov/hazardouswaste/
perchlorate.
Perchlorate material – lithium battery contains perchlorate.