Software, Version 2.1 Owner's manual

Section 6 Data Analysis Module
- 100 -
performed by activating the Enable for Gene Study button found in the Gene Expression
window of the Data Analysis module (Figure 6.57).
Fig. 6.57. The Enable for Gene Study button is located above the plate interface
section of the Gene Expr tab window.
When a file has been saved with the Enable for Gene Study button active, it allows the saved file
to be added to a Gene Study. The default setting is that this button is not enabled. You must
save your data file after activating this option from within the Gene Expr tab window.
Gene Study Errors
The file must be saved with the Enable for Gene Study button selected. If a file with the
Enable for Gene Study is not selected and there is an attempt to add the file to a Gene Study, an
error will be received (Figure 6.58).
Fig. 6.58. Gene study error message indicating that the file was not enabled.
To correct this error:
1. Click OK to clear the error message.
2. Re-open the file that will be added to the Gene Study.
3. Confirm that all wells to be analyzed have valid C
T
values and activate the Enable for
Gene Study button.
4. Save the file.
5. Attempt to add that file to the Gene Study once again.