Instruction manual

Fill in Chapter Name Here on Master Page (33_man_left header/footer)
QX100 Droplet Generator Instruction Manual
Chapter 3 Using QuantaSoft Software
3.3 Analyze
In the Setup window, load a plate (filena me.qlp), then click Analyze to open and analyze the data. The data
analysis interface is separated into three windows:

Results table — summarizes results for wells selected in the well selector

Well selector — enables selection of wells for targeted analysis

Processed data/graphical display — allows visualization of graphical data from selected wells
Well data stream
Channel 1 histogram
(events vs. amplitude)
Run indicator
Analyzed wells
Switch data views
(charts to larger
window)
Interface during an active run. Data for both detector channels are shown for the well being read.
Experiment
Conc. channel 1 unknown
Conc. channel 2 unknown
Sample name
Channel 1 (FAM) fluorescence vs. event number Channel 2 (VIC or HEX) fluorescence vs. event number
Channel 2 histogram (events vs.
amplitude)
14 | QX200 Droplet Reader and QuantaSoft Software Instruction Manual