Attach shelf (B) to table leg (C) using CBC bolt (G), spring washer (H) and lat washer (1). Do not fully tighten with Allen wrench (E). Attach the other table leg (C) to shelf (B) using CBC bolt (G), spring washer (H}) and flat washer (1). Do not fully tighten with Allen wrench (E).
Align and fasten mounting plate (D) with sticker arrow as shown below to table leg using CBC bolt (F), spring washer (H) and flat washer (I). Tighten with Allen wrench (E). ** Do not fully tighten the bolt until all bolts are attached. Place table top (A) upside down on soft surface. Align and fasten mounting plate (D) to other mounting plate on table top (A) by using CBC bolt (F), spring washer (FH) and flat washer (I) and tighten with Allen wrench (E). Screw in the leveler (J) to bottom of table leg (C).
Align and fasten handle (K) to drawer head using screw. Tighten with screw driver (not provided). Cleaning & Care Treat Surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a dry or damp soft cloth. Do not use abrasive cleaners . Hardware may loosen over time. Periodically check that all connections are tight.