User's Manual

Mobile Phone Operations
TUNE 2 FIT App
Download Tune2Fit.apk file from http://www.iclear-digital.com
(Only applicable for Android)
Open the file and install the app.
NOTE: To tune the hearing assistive device using the Tune2Fit app you would need to pair
the unit with an Android Smartphone.
EN
Hold ‘Up’ and ‘Down’
2 seconds
Pairing mode
Pairing completed
Turn on Bluetooth
search for
ICLEAR HAD1000
I
PAGE 18
General Operations
Your hearing assistive device is now all set and ready to go!!!
The operations described here are applicable to all modes of
operations.
Power On
Hold the ‘Power’ button for 2 seconds to power
on the hearing assistive device. The status
indicator will blink blue and a power up tone
can be heard.
Power Off
To switch off the hearing assistive device, press
and hold the ‘Power’ button for 5 seconds. The
status indicator will blink red 5 times followed
by a long beep before fully shutting down.
Power Save Mode (Auto Power Off)
If the hearing assistive device feature has not been in use and not connected to any other
devices, the system will auto shut down in 5 minutes.
Low Battery
When the battery level is low, the status indicator light will flash red twice every 2 seconds
while emitting a warning beep every minute.
Charging
To charge the helmet communicator, connect it to the adaptor/ USB Port with the USB
charging cable provided. Upon charging, if the unit is on, the system will automatically
initiate power down.
Volume Control
The volume control of the helmet communicator can be controlled using the ‘Up’ and ‘Down’
buttons. Press ‘Up’ or ‘Down’ button will increase the volume respectively. The volume
control for each mode is independent of each other.
Automatic Speaker Loudness (Communication only)
The speaker loudness will be automatically adjusted depending on the environment noise level.
However you can still adjust the volume manually.
Automatic Pairing
• Hearing assistive device has the ability connecting to the last paired device automatically for
two features - music and mobile phone.
• Automatic pairing of the control unit with music devices is dependent on the music devices.
Automatic Profile Switch
The hearing assistive device supports multiple profiles concurrently, but at any point in time only
one profile is active. The automatic profile switch determines which profile should be active at
any point of time starting from the highest priority:
(1) Mobile phone functions
(2) Music functions.