User manual

139
The following describes the specific commands that may be used to
communicate with each connected instrument with this specific
setup.
Remote Commands via USB
The following lists all the available commands to control multiple
power supplies with the multi unit programming configuration
illustrated in “Figure 30”. For all configuration commands (except for
commands listed under Synchronous Control Commands
section), the instrument will return a string “OK” to indicate
command sent successfully. If an error occurs, it will return an error.
See the “Error List” section for details.
System Control Command
This set of commands is used to select the instrument (based on
their address) to control and to obtain/set its system settings.
CADR
CCLS
CRST
CIDN?
CREV
CSN?
CST?
CCLR