User manual

Adds RS-485 interface for multi power supply control

Option 5: RS232 Card

Adds RS-232 interface

How to Install Interface Cards

1. Power off the instrument and disconnect the AC power cord

in the rear panel. Remove the back faceplate covering the

S1 or S2 slot in the rear panel by removing the two screws

on each side.

2. Make note of the metal notches that indicate where the card

should slide into. Inside the slot, there are two rails (left and

right side) where the card should slide smoothly into. The

very back of the slot is a 48-pin female connector that should

connect with the 48-pins on the back of the interface card.

3. The interface card should go right below the metal notches

on both sides and fit in between the inner card rails, also on

: : : : : : : : : : : : : : : : : : : : : :

Metal

notch

Card

rail

48-pin female connector