User manual

3.2 Remote Interface Setup

The standard remote interface available on all models in the series

is the USB (virtual COM) interface. Other optional supported

interfaces such as GPIB, Ethernet (LAN), RS-232, and RS-485are

available, but dependent on the interface card(s) installed on the

instrument. This section will describe how to setup all the supported

interfaces.

Note: The RMT LED will automatically light up when the power

supply is successfully connected to a PC remotely through any

remote interface. Keys on the front panel will be locked until

(LCL) is pressed to set the instrument back to LOCAL mode.

USB Interface (virtual COM)

The USB interface comes standard on every power supply in the

series. A USB Type A to Type B cable (i.e. USB printer cable) is

required to connect the USB port ( ) in the rear panel to a PC.

Follow the steps below to setup the power supply for USB (virtual

COM) remote communication.

1. Press , then to enter SYSTEM SETTING. Select

REMOTE and verify that it shows USB, which is the default

option. If not, press or until “USB” is displayed.

Press to save changes.

Enter