User manual

GPIB Interface

GPIB interface is available when the LAN/GPIB card is installed in

the “S1” or “S2” slots in the rear panel. To setup the power supply

for GPIB interface, follow the steps below:

1. Press , then to enter SYSTEM SETTING. Select

REMOTE and press or until “GPIB” is displayed.

Press to save changes.

2. Select GPIB ADDR and use the numeric keypad to enter the

GPIB address (1 – 30). Press to save changes.

Ethernet (LAN) Interface

LAN interface is available when the LAN/GPIB card is installed in the

“S1” or “S2” slots in the rear panel. To setup the power supply for

LAN interface, follow the steps below:

1. Press , then to enter SYSTEM SETTING. Select

REMOTE and press or until “ETHERNET” is

displayed. Press to save changes.

2. Select IP CONFIG and choose STATIC. Press to

save changes.

STATIC

Allows you to configure a static IP address for

the power supply.

Enter