User manual

3. If STATIC is selected, then select IP ADDRESS and use the

numerical keypad to enter the static IP. After entering each

group of 3 digits, press to go to the next group. The

cursor will automatically move to the next group. Do this until

all 12 digits are entered. Be sure to press one more

time after entering the last 3 digits for the complete IP

address entry to be saved.

RS-232 and RS-485 Interface (Optional)

Both RS-232 and RS-485 interface are supported by the power

supply through an optional RS-232 or RS-485 interface card. Both

of these card options must be properly installed before they can be

used. See “1.7 Installing Optional Interface Cards” for details.

RS-232 Interface

The setup for remote control via RS-232 interface is very similar to

the same for USB virtual COM interface. To setup the power supply

for RS-232 operation:

1. Press , then to enter SYSTEM SETTING. Select

REMOTE and press or until “RS232” is displayed.

Press to save changes.

2. The settings used for RS232 communication are:

Enter