User manual

Enable/Disable Output

WARNING:

Before connecting wires to the front or rear panel

output terminals, output should remain OFF to

avoid shocks and damage to the device under test

(DUT), especially when setting the supply for high

voltage output. For safety, load wires must have a

wire gauge size large enough to prevent

overheating when the power supply operates at

maximum short circuit output current. It will also

prevent large voltage drops from resistances in the

wires.

The button is used to enable or disable the supply output

from both the front panel and the rear panel output terminals. A

green LED light next to the button will be lit when is

pressed to turn ON (enable), and the OFF annunciator will

disappear from the display. This will reappear when output is OFF

(disable) upon pressing again, and the green LED light

will disappear. For dual channel models, and are used

in place of as output ON/OFF for CH1 and CH2

respectively. Dual channel models can also be configured so that

both channels’ output states (ON or OFF) can be synchronized. See

“

3.6Dual Channel Configurations” under “Multi/Single Output

Control” for setup instructions.

OUTPUT

CH1

CH2

OUTPUT