User manual

Note: When multiple output control is setup, there will be a maximum of 3

ms delay between channel 1 and channel 2 when both channels change

output from OFF (disable) state to ON (enable) state.

Follow the steps below to configure this setting:

1. Press , then to enter SYSTEM SETTING. Go

down the list of settings and select OUTPUT MODE.

2. Press to select MULTI. Press to confirm the

changes, and press twice to exit the menu. If SINGLE

is selected, output control of the two channels will not be

simultaneous; their output states can be controlled

independently.

Series/Parallel Tracking Mode

Tracking mode can be enabled so that both channels can be

synchronized, especially when connected together in series or

parallel. To turn on tracking mode, follow the steps here:

1. Press , then to enter SYSTEM SETTING. Go

down the list of settings and select TRACKING MODE.

2. Press to select ON. Press to confirm the changes,

and press twice to exit the menu. To disable it, select

OFF.

Enter

Esc

Enter

Esc