User manual

for setting the power on state to last known configuration.

Select OFF to turn it off.

2. Press to confirm the change.

3.11 Sequence Program Mode

Up to 10 (1 – 10) programmed sequences can be stored into the

internal memory of the power supply and be executed from the front

panel or via remote commands. A sequence consists of various

steps of voltage and current values with a user defined time to hold

at each step. This allows the user to change the voltage and current

output of the power supply at different timings in a sequence. The

maximum number of steps per sequence is 150, and the

minimum timing in between steps is 10 ms. For dual channel

models, the programmed sequence will control both channels

per every step. Programming a sequence for each channel

independently is not supported.

Sequences must be programmed into the memory via remote

interface (i.e. USB, GPIB, Ethernet) before it can be executed from

the front panel. See “4 Remote Operation” for details.

Assuming that sequences are already programmed into the internal

memory, follow these steps to execute a program.

1. Press , then to enter PROGRAM MODE. The

following screen will be displayed:

Enter