Console Servers User Guide 16 port , 24 port

Black Box Console Server user guide 221
Upgrade using JETset, the web browser
interface
1. Start JETset by pointing your network browser at the Internet Address of your the
unit.
2. Log in as the Admin user and select file transfer from the main menu.
3. Complete the file transfer form by selecting software download from the pull-
down menu, and completing the internet address of the TFTP server and the
download software image filename.
4. Select save from the main menu to start the download process. Your browser may
ask you to confirm this action before the download will start.
The new software will download and written to FLASH memory, see Writing to FLASH
memory on page 219. You can monitor the progress of this operation with a terminal (or
terminal emulation) connected to the Admin port at the rear of the unit.
WARNING DO NOT SWITCH OFF THE UNIT whilst the unit is programming the FLASH memory.
Enabling BOOTP/DHCP after upgrading
software
If you require automatic BOOTP/DHCP configuration, be sure to set the server DHCP
parameter to ON:
set server dhcp on
Save the configuration:
Save
Disable BOOTP/DHCP
The server parameter DHCP is used to disable BOOTP/DHCP (set server dhcp on/off ).
Setting DHCP to OFF prevents the unit from initiating a BOOTP/DHCP request. This
parameter is only accessible from the CLI.
RARP is unaffected by this parameter.