User's Manual

V.25 bis Autodialer
11-4 Modem 3600
3) Any parameter containing too many characters.
INVPVThis message has one of three possible meanings:
1) Any parameter set containing invalid characters
2) Any parameter or parameter set containing no valid (only
ignored) characters
3) Any parameter set containing an out-of-range parameter
Dial Parameters
Table 11-1 lists and describes the parameters used in autodialing. The
memory available for dialing can hold up to 40 characters. Parameters
inserted for readability are not counted.
V.25 bis Commands and Responses
The following sections describe the commands used with the V.25 bis
autodialer and explain the responses received when each command is
executed.
Parameters Function
0 thru 9 DTMF and pulse digit
* and # DTMF digit
W Wait for 2nd type of dial tone
> Pause for 1 second
= Pause for 3 seconds
< Pause for programmed delay time
P Pulse dialing
T Tone dialing
& Flash (go on hook) for ½ second
; PARM separator
Space, dash,
parenthesis, period
Parameters inserted for readability