User's Manual
101
5.0 Hayes Emulation Mode
Table 5-1 (continued). Hayes Compatible Commands.
COMMAND FUNCTION/EXPLANATION
&T Test Commands
&T0 Terminates a test in progress. &T0 must be the last
command in a command line.
&T1 Initiates a local analog loopback test.
&T3 Initiates a local digital loopback test.
&T4 Allows the local modem to accept a request from the
remote modem for a remote digital loopback test.
&T5 Prevents the Modem from accepting a request from the
remote modem for a remote digital loopback test.
&T6 Initiates a remote digital loopback test.
&T7 Initiates a remote digital loopback test self-test.
&T8 Initiates a local analog loopback self-test.
&V View Active Configuration, etc.
&V0 Displays modem configuration, user profiles and phone
numbers stored in memory cells 0-5.
&V1 Displays all stored phone numbers (contents of memory
cells 0-9).
&W Write Profile To Memory
&W0 Saves storable configuration parameters as
user profile 0.
&W1 Saves storable configuration parameters as
user profile 1.
&X Transmitter Clocking *
&X0 Selects internal clocking.
&X1 Selects external clocking.
&X2 Selects receive mode (slaved) clocking.
&Y Default User Profile
&Y0 Stored user profile 0 will be recalled on powerup.
&Y1 Stored user profile 1 will be recalled on powerup.
Default settings (where applicable) are in bold face.
* If user profile 1 is active, options are controlled (for Hayes mode
operation) by given commands or Summary Setup. Do not change via
front panel (except via Summary Setup).