User's Manual

135
APPENDIX C: Summary Setup
Appendix C: Summary Setup
C.1 Introduction to Summary Setup
Summary Setup is designed to allow experienced users to quickly change
option settings for any mode. There are three Summary Setup screens:
SETUPS, AT PROFILES, and S-REG. They are briefly described on the
next page.
Because the screens show numerical codes with very little explanation,
Summary Setup is recommended for experienced users only. Changes
made through Summary Setup modify the active modem configuration
and are saved to memory when you exit Summary Setup.
A CCESSING S UMMARY S ETUP
Summary Setup is accessed from screen 6 of the SETUP menu. The
SUMMARY screen includes a four-digit checksum value to the right of the
word SUMMARY. This number changes if any of the option settings are
changed. You can determine if any of the modem’s settings were changed,
but you cannot determine what options were changed.
From the SUMMARY screen, choose SETUPS to change options, AT to
change options that are associated AT commands, or S-REG to change S
Register values. (See Figure C-1.)
K EY TO THE
S UMMARY S ETUP S CREENS
Each Summary Setup Screen is essentially the same: brief descriptive
information on the top line and a long string of numbers on the bottom line.
The numbers are broken down into groups that represent a category
of options (for example, EIA interface options).
Each digit position represents an option, and the number in each digit
position indicates the current option setting (parameter). The diagrams
in this appendix show the following information:
• Which options are included in each option group
• Which option is indicated by each digit position within the group
• The possible parameters for each option.
NOTE
The number in each digit position is the current iption setting
(parameter). The diagrams of this Appendix show the factory-default
setting for each option.