User's Manual

14
Modem 34336
All options for each Quick Setup configuration are listed in Appendix B.
If you want to customize your Quick Setup configuration, see 3.0, Modem
Setup Options. For Hayes
®
mode options, see 5.0, Hayes Emulation Mode.
Table 2-1. Available Quick Setup Configurations.
QUICK SETUP
IDENTIFIED ON LCD DESCRIPTION
QUICK SETUP <01> 2-WIRE DIAL HAYES EMULATION MODE— This
2-W DIAL (Hayes) dial mode (for use over ordinary phone lines) allows the
Modem to automatically dial (autodial) a previously
stored phone number and respond to Hayes commands.
This mode is compatible with communication software
packages that use Hayes-style AT commands. The
Hayes mode Quick Setup is the factory default
configuration for the Modem.
QUICK SETUP <02> 2-WIRE DIAL V.25 bis MODE,
V25 DIAL (Async) ASYNCHRONOUS—In V.25 bis mode, the Modem
operates in conformance with CCITT recommendation
V.25 bis, allowing you to store and direct dial or autodial
phone numbers from the DTE. Use Quick Setup 2 if the
DTE connected to the modem is asynchronous.
QUICK SETUP <03> 2-WIRE DIAL V.25 bis MODE, SYNCHRONOUS-
V25 DIAL (Syn_c) CHARACTER ORIENTED— Same as Quick Setup 2
except for data protocol. Use Quick Setup 3 if the DTE is
synchronous-character oriented (bisynchronous).
QUICK SETUP <04> 2-WIRE DIAL V.25 bis MODE,
V25 DIAL (Syn_b) SYNCHRONOUS BIT ORIENTED—Same as Quick
Setup 2 except for data protocol. Use Quick Setup 4 if
the DTE is synchronous bit-oriented (SDLC/HDLC).
QUICK SETUP <05> 2-WIRE DIAL DUMB MODE—When the Modem is in
2-W DIAL (DUMB) Dumb mode, you can use it for dial-line answer-only
applications, dial a previously stored telephone number
from the front panel, or dial telephone numbers via an
external source (telephone).
QUICK SETUP <06> 2-WIRE LEASED-LINE ORIGINATE MODE—
2-W LEASED (ORG) In Leased-Line mode, the Modem connects to the leased
line and stands ready to send and receive data. Use
Quick Setup 6 if the leased line is a 2-wire line and you
want to configure the Modem as the originate modem.