User's Manual

8
Modem 34336
2.0 Quick Start
All information in this manual applies to both the stand-alone and rack-
mount versions of the Modem 34336.
Q
UICK
S
ETUPS FOR A
Q
UICK
S
TART
The simplest and fastest way to set up the Modems for immediate use is to
select one of the factory-preset Quick Setup configurations.
Quick Setups are explained in Section 2.3, following installation instructions
(Section 2.1) and a brief introduction to the Modem’s front-panel display and
controls (Section 2.2).
2.1 Installation
2.1.1 U
NPACKING
Many early modem failures are a result of damage done during shipping.
Visually inspect your modem. Keep the original shipping carton in case
you have to return the modem for any reason.
2.1.2 P
ACKAGE
C
ONTENTS
All models include the following cables:
A two-conductor crossover cable for a dial-line connection.
A four-conductor cable for a leased-line connection.
Both cables have an eight-pin modular connector (RJ-45) on one end and
a six-pin modular connector (RJ-12) on the other end. You will need to use
both of the supplied cables if you want to use the Modem for Leased-Line
Auto Recovery, which requires both a leased-line and dial-line connection.
The MD885A-R2, MD885AE-R2, and MD885A-R3 include a power supply.
The MD885A-R3 package also includes additional cables:
(1) 10-ft. RS-232 cable
(1) DB9 F to DB25 M adapter
2.1.3 W
HAT
Y
OU
W
ILL
N
EED
You will need an EIA RS-232 interface cable (supplied with the MD885A-
R3, not supplied with the MD885A-R2, MD885AE-R2, or MD885C-R2) to
connect the Modem to a DTE (data terminal equipment, usually a
computer).