User's Manual

5.0 Hayes Emulation Mode

• If profile 0 is recalled as the active configuration, the LCD screens reflect

the profile 0 configuration.

• If profile 0 is changed by means of Hayes commands or via the Summary

Setup feature and then saved, the changes made are reflected on the

LCD and are effective for all modes.

If you make option changes from the front panel without exiting the SETUP

menu, and then make option changes using Hayes commands and use the

&W command to save them to profile 0, the changes saved to profile 0

override the front-panel selections.

User Profile 1 is not linked to the front panel.

• Option changes made from the front panel are not saved to profile 1.

(Profile 1 can be changed only by using Hayes commands or the

Summary Setup feature.)

• If profile 1 is recalled as the active configuration, the LCD screens are not

affected. When profile 1 is active, it is possible for the LCD to display an

option setting not reflecting the setting currently in effect.

• If profile 1 is changed by means of Hayes commands or via the Summary

Setup feature, the changes are not reflected on the LCD and only affect

Hayes mode operation.

If profile 1 is being used as the active configuration, the options marked

with an asterisk (*) in Table 5-1 should be controlled either with the AT

commands listed in Table 5-1 or using the Summary Setup feature described

in Appendix C. When Profile 1 is active, these options can be changed via

the front-panel LCD, but the changes are effective only for Hayes mode

operation. However, if Profile 0 is subsequently recalled as the active

configuration, the changes are effective at that time.

5.5 Hayes Mode Reference Tables

Table 5-1 lists the Hayes compatible commands used with the Modem.