Service manual

– 5 –

4. NOTE ON MOUNTEING SLED MOTOR

1) Push the sled motor assy 1 toward direction A. (See Fig.5)

2) Tighten two screws 2 (M1.7 × 2.5).

3) Raising the MD block assy 3 90 º with the side down.

confirm that the optical pick-up 4 falls by self weight.

(See Fig. 6)

4) Further, with the front side of MD block assy 3 up, confirm

that the optical pick-up falls by self weight.

1 Sled motor ass’y

2 Two screws (M1.7 × 2.5)

Fig. 5

3 MD block ass’y

4 Optical pick-up

Front side

Lower

Upper

Front side

Lower

Fig. 6