ServSwitch User's Manual

59
CHAPTER 4: Full Configuration
4.5 Configuring User Definitions
You can use the “Configure User” page to assign a username, password, and profile
for each user.
Figure 4-6. The “Configure User” page.
Here are the user-configuration parameters:
User name
Use this field to define a name for each user that will be associated with that user’s
access rights and characteristics. At any user station that has logins enabled (see
Section 4.3), users must enter their usernames and passwords to log into the
Matrix ServSwitch system. Usernames may be up to 8 characters long. Duplicate
names may be used; however, all persons with the same username will have the
same access rights. Factory defaults are “User 1” through “User16”.
Password
Use this field to assign a password to each user. At any user station that has logins
enabled (see Section 4.3), users must enter their usernames and passwords to log
into the Matrix ServSwitch system. Passwords can be up to 8 characters long and
are case-sensitive. Passwords are not shown when you type them in the password
field. Factory default is no password.
Configure user
User login name, up to 8 characters
User name Password Profile
User 1 ******** Profil 1
User 2 ******** Profil 2
User 3 ******** Profil 3
User 4 ******** Profil 4
User 5 ******** Profil 5
User 6 ******** Profil 6
User 7 ******** Profil 7
User 8 ******** Profil 8
User 9 ******** Profil 9
User10 ******** Profil10
User11 ******** Profil11
User12 ******** Profil12
User13 ******** Profil13
User14 ******** Profil14
User15 ******** Profil15
User16 ******** Profil16
User 1