Instructions / Assembly
Page 10
INSTALLING THE BEER TAP
Follow the steps below to install the beer tap.
• Place the beer tower rubber washer on top of the unit prior to installing the
dispenser. (See illustration A).
• To install the dispenser, place it on top of the kegerator unit, and screw into place.
Three screws are needed to lock the dispenser into place. (See illustration B).
• Connect the Keg Couplers to the CO Regulator with the air hose. Then connect
the keg couplers to the beer taps. (Illustration C).
• Connect the CO Regulator to the CO bottle. (Illustration D).
SET UP & USE
D
Air Hose Connecting Beer Tap to
Regulator & CO Bottle
Hose #2 Connecting Dispenser
Assembly to Beer Tap
CO Bottle
Part Shown in Illustration C,
Connects to Keg
Keg Coupler
CO Regulator
C
Large Butterfly Nut Secures Hose
to Beer Tap
Beer Tap Shown connected to
Regulator by Hose
Air Hose Connecting
Beer Tap to Regulator &
CO Bottle
A
B