Manual

PREPARATION
PLEASE REFER TO DIAGRAMS (A, B, C...) AND iTEM NUMBERS (1,2, 3...) AS NOTED THROUGHOUT MANUAL. FOR EXAMPLE,
A=I REFERS TO iTEM 1 iN FIGURE A.
UNPACKING - (FIGURES A, A1, A2)
STEP 1:
Raise the handle section A-1 into place and secure by tightening the two
lower knobs A=2. Be careful not to pinch power cord.
_CAUTION: Pinch point. To avoid being pinched, keep fingers away
from area between handles when raising.
STEP 2:
Carefully cut down the sides of the,box on the opposite end of the handle
and fold the flap down as shown. _.v WARNING: Sharp blade. Keep
body parts away from blade.
STEP 3:
With the carton end cut open, remove the cardboard filler, charger,
accessory bag and grass bag and push the mower out of the opened
carton.
HANDLE ADJUSTMENT - (FIGURE B)
Your mower has a variable height handle adjustment feature. To adjust the
handle position to suit your height preference, use the following procedure:
1. Remove both hex nuts and fiat washer B-1 on the middle part of the
handlebars using a 1/2 inch wrench. Remove the carriage bolts B-2.
2. Slide the upper handle into one of the 3 adjustment positions B=3,
aligning the holes in the upper and lower handles.
3. Insert carriage bolts and install the flat washers and hex nuts, tighten
securely.