Use and Care Manual
FUNCTIONAL DESCRIPTION
1. Switch box
2. Bail handle
3. Upper-handle
4. Lower-handle
5. Upper-handle attachment levers (2)
6. Lower-handle attachment levers (2)
7. Cut height adjust lever
8. Grass collection bag
9. Rear door cover
10. Battery port
11. Battery storage compartment
12. Carrying handles
13. EdgeMax™
5
using identical replacement parts.
DANGER: ADDITIONAL
WARNINGS FOR MOWERS
Avoid dangerous environment –
don’t use lawn mowers in damp or wet
locations.
Don’t Force Lawn Mower – It will do
the job better and safer at the rate for
which it was designed.
Don’t Overreach – Keep proper
footing and balance at all times.
Stay Alert – Watch what you are doing.
Use common sense. Do not operate
lawn mower when you are tired.
Store Idle Lawn Mower Indoors –
When not in use, lawn mower should
be stored in an indoor dry and locked-
up place – out of reach of children.
Remove safety key
Maintain Lawn Mower With Care –
Keep cutting edges sharp and clean
for best and safest performance.
Keep guards in place and in
working order.
cutting area.
persons. The lawn should always be
carefully examined and cleared of all
objects prior to each mowing.
If lawn mower strikes a foreign
1) Stop lawn mower. Release the bail
handle.
2) Remove battery and safety key.
3) Inspect for damage.
4) Repair any damage before restarting
and operating the lawn mower.
only.
WARNING: Some dust created by
this product contains chemicals known to
the State of California to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
herbicides and pesticides
chemically treated lumber
To reduce your exposure to these chemi-
such as dust masks that are specially
designed to filter out
microscopic particles.
following symbols. The symbols and their
definitions are as follows:
V ..................volts
mW..............milliwatts
nm ...............wavelength in nonometers
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ...... alternating current
or DC ...direct current
n
o ................no load speed
................Class I Construction
(grounded)
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
reciprocation per minute
.................
Use proper respiratory protection
................. Read instruction manual before use
................Use proper eye protection
...................Use proper hearing protection
6
2
3
4
1
5
9
11
12
13
8
10
12
7