Use and Care Manual

12
 •Windthecuttinglineontothespoolin
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure U).
 •Whenthewoundcuttinglinereaches
the recesses (T2), cut the line. (figure T).
 •Fitthespoolontothetoolasdescribed
in “REPLACING THE SPOOL”.
Maintenance
WARNING: To avoid serious injury, remove the battery from
the tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top
condition,storesparepre-woundspoolsorbulklineinaplastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommendedyouperiodicallytouch-upthesharpnessofthe
blade with a file.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorizedservicecentersorotherqualifiedserviceorganizations,
always using identical replacement parts.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling
Corporation)SealontheLi-Ionbattery(orbatterypack)
indicates that the costs to recycle the battery (or battery pack) at
the end of its useful life have already been paid by Black & Decker.
RBRC™ in cooperation with BLACK+DECKERand other battery
users, has established programs in the United States to facilitate the
collectionofspentLi-Ionbatteries.Helpprotectourenvironmentand
conservenaturalresourcesbyreturningthespentLi-Ionbatteryto
an authorized BLACK+DECKERservice center or to your local retailer for
recycling. You may also contact your local recycling center for information on
where to drop off the spent battery.
RBRC™ is a registered trademark of the
Rechargeable Battery Recycling Corporation.
Thisdevicecomplieswithpart15oftheFCCrules.Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: Thisequipmenthasbeentestedandfoundtocomplywith
thelimitsforaClassBdigitaldevice,pursuanttoPart15oftheFCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipmentgenerates,usesandcanradiateradiofrequencyenergy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
Ifthisequipmentdoescauseharmfulinterferencetoradioor
television reception, which can be determined by turning the
equipmentoffandon,theuserisencouragedtotrytocorrectthe
interference by one or more of the following measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Connecttheequipmentintoanoutletonacircuitdifferentfromthat
to which the receiver is connected.
•Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Changes or modifications to this unit not expressly approved by the
partyresponsibleforcompliancecouldvoidtheuser’sauthorityto
operatetheequipment.ThisClassBdigitalapparatuscomplieswith
CanadianICES-003.
U