Use and Care Manual

trouBLe Shooting continueD
14
THREE-YEAR LIMITED WARRANTY
Black & Decker (U.S.) Inc. warranties this product to be free from
defects in material or workmanship for a period of three (3) years
following the date of purchase, provided that the product is used in
a home environment. This limited warranty does not cover failures
due to abuse, accidental damage or when repairs have been
made or attempted by anyone other than BLACK+DECKER and
its Authorized Service Centers. A defective product meeting the
warranty conditions set forth herein will be replaced or repaired at no
charge in either of two ways:
The first, which will result in exchanges only, is to return the product
to the retailer from whom it was purchased (provided that the store
is a participating retailer).Returns should be made within the time
periodoftheretailer’spolicyforexchanges.Proofofpurchasemay
berequired.Pleasecheckwiththeretailerforitsspecificreturn
policy regarding time limits for returns or exchanges. The second
option is to take or send the product (prepaid) to a BLACK+DECKER
owned or authorized Service Center for repair or replacement at
BLACK+DECKER ’soption.Proofofpurchasemayberequired.
BLACK+DECKER owned and authorized service centers are listed
online at www.blackanddecker.com.
This warranty does not apply to accessories. This warranty gives
you specific legal rights and you may have other rights which vary
fromstatetostate.Shouldyouhaveanyquestions,contactthe
manager of your nearest BLACK+DECKER Service Center. This
product is not intended for commercial use, and accordingly, such
commercial use of this product will void this warranty. All other
guarantees, express or implied, are hereby disclaimed.
LATIN AMERICA: This warranty does not apply to products sold in
Latin America. For products sold in Latin America, check country
specific warranty information contained in the packaging, call the
local company or see the website for such information.
ProBLeM
Overfeeding
Line unravels when cap or spool
is removed.
SoLution
•Removethespoolandunwind
the cutting line, then wind it on
neatly again. Replace the spool
into the housing.
•Ensureyouarecuttingwith
thetipoftheline(7inches
(177.8mm)fromthespool).
Use the edge guide if needed to
ensure proper space is
maintained.
•Ensureyouarenot
exceeding a 10° angle as
shown in figure N1.
•Makesuretoparkthelinesin
holding slots (S2) figure S
before removing.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.